Ceiling leaks can happen due to many reasons. It is crucial to understand how to identify the ceiling leak and what are its signs? Ceiling leaks indicate a bigger problem in the roof, upper roof, or attic. To repair the ceiling leak, identifying the leak, tracing its origin, and stopping it must be done. Usually, we don’t look at the ceiling without reason, which is why the leak might get missed out. However, you might spot the leak early if you practice cleaning the home from top to bottom every week. Plumber company in Phoenix can fix any leakages with the Rooter Hero Plumbing and Air support team.
Signs of ceiling leak: –
If you are locating a water drop falling from the ceiling, you might be too late to discover the leakage. It does not leak that way, but there will be some indications. Most ceilings show signs of leaks like paint strain on the wall or wt surface of the wall. It could be due to several reasons but relevant to the problem at the roof. Following signs can show the leaks –
- Bubbled paint
- Dark or rancid water
- Events causing leaks
One can do the homework before going for the repair to stop the leakage. For that, you have to examine for the internal and external leakage.
Internal ceiling leaks –
- Pooled water – You need to look for the water’s end-point. If the pooled water is observed, mark the area with chalk, a bucket, or tape.
- Check for condensation – if condensation is the cause of the leak, install an exhaust or run a dehumidifier.
- Look upward where water is pooled – There has to be a drip area on the ceiling, which might be spotted even after the water dries. Plumber Phoenix can help locate the exact spot.
- Mark the leak area – If the site is spread wide, mark the outline with a pencil. You need to check the doubtful area too.
- Inspect the upper floor – The area above the leak spot has to be inspected for the leak’s origin. If the bathroom is there, there is a chance of such a leak.
- Check the bottom of the roof – You need to check the area on the roof by judging the exact location. It could be ceiling drywall, so underside leaks of this type start high and move downward.
External ceiling leaks –
- Check drain points – It could be due to the blockage of the drain. In such cases, water pooling will be there all over the roof, or sometimes it can be a backlash of the drain.
- Check the roof – The leakage can be due to raised, missing, or damaged shingles at the roof.
- Check roof ridge and flashing – Check the roof shingles along the ridge. The metal step flashing near the chimney can also result in a leak.
How to repair internal leaks?
When you find a dried water spot on the ceiling, do not delay further to investigate the reason. Sometimes, we feel it is a small thing and leave it, which causes further damage. You will soon see paint peel off if the leakage continues. It is always recommended to call field expert Plumber Phoenix if you feel it is worrisome.
The professional will do their job, but for our knowledge, we must learn the process too. Here are some steps to repair a ceiling damaged by leaks –
- Remove all water pooled over the ceiling drywall and insulation.
- Cut the drywall (including undamaged ones) to the nearest joists.
- Add two-by-fours along with the joists to provide an attachment surface for the drywall screws.
- Cut a sheet of drywall 5/8 inch thick to the size of the missing panel.
- Lift the drywall into place.
- Screw the drywall onto the joists with a drill and drywall screws.
Call for professional: –
Usually, these tasks are difficult DIY unless you are trained for them. Locating the leaks is easy, but finding the origin may need an expert’s help. Furthermore, being a layman, there is a high risk of doing them.
Conclusion: –
While ceiling leaks do not occur now and then, it is better to have vigilance periodically, especially in the rainy season. You can have the support of Plumber Phoenix near you, who is well-equipped and experienced while working with Rooter Hero Plumbing and Air.
